ZAHRA Wardrobe

Steps

1. 1

   Step 1

   Prepare

   Open the boxes on a rug or flattened cardboard. Sort the parts by letter and check them against the list.

2. 2

   Step 2

   Build the frame

   Push the dowels and cam bolts into their holes. Join the sides, top, bottom and dividers, then turn each cam lock a quarter turn.

   Parts

   Hardware

   • ×16 Cam lock Ø15 + screw-in bolt (drilling distance 24 mm)
   • ×6 Beech dowel Ø8×35
3. 3

   Step 3

   Fit the base

   Screw the base under the frame, lining up its edges before tightening.

   Parts
4. 4

   Step 4

   Fix the back

   Lay the frame flat, check it is square by measuring both diagonals, then screw the back panel all round.

   Parts

   Hardware

   • ×10 Chipboard screw 3.5×16
5. 5

   Step 5

   Fit the rail

   Screw on the supports and clip the rail in.

   Hardware

   • 0.46 m Oval wardrobe rail 30×15 mm
   • ×2 Oval rail end support
6. 6

   Step 6

   Hang the doors

   Screw the hinges to the doors, clip them onto their plates, then align the doors with the hinge screws.

   Parts

   Hardware

   • ×3 Cup hinge Ø35
   • ×6 Euro screw 6.3×13 (hinge plates)
7. 7

   Step 7

   Fix to the wall

   Fix the piece to the wall with the supplied hardware, using plugs suited to your wall. Essential for tall or wall-hung pieces.

   Hardware

   • ×1 Anti-tip wall strap kit (EN 16122)
8. 8

   Step 8

   Finishing

   Fit the screw and cam covers, the felt pads and the accessories.

   Hardware

   • ×4 Felt pad Ø28
   • ×16 Cam cover cap Ø15